Handheld - Fully functional wall mount/handheld touchscreen unit used to control the entire house remotely.
ABS case with aluminum accents and molded rubber feet.
Handheld first shot - After the initial model is created, tooling was made and this is one of a short production run. It needs to be cleaned, painted, and get graphics applied. We did the whole first production run by hand.
Layers - Various pieces to the handheld unit, not including the internals.
Kickstands - One part that we didn't have any first shots for were these kickstands which we made and finished by hand.
ABS with overmolded rubber feet and sheetmetal stamped off site.
Production - A production run we made out of first shots. Most of the basic plastic was supplied to us. We then needed to clean it all up, paint, and apply graphics.
Finish - The various stages of finish, starting with the raw part off the machine at the bottom progressing through sanding grits and polish and final brushed/polished finish at the top.
Cradle - Detail shot of the cradle used to hold the handheld unit.
ABS with polished aluminum.
AMX remotes - Photomodel for marketing. ABS and renshape housing with polished aluminum accents and a brushed steel faceplate (laser cut off site)
AMX remotes - Photomodels created for marketing. ABS housing with polished aluminum accents, brushed steel faceplates (laser cut off site) and dry transfer graphics.
gLike
Ignition AMX