• About
  • Portfolio
  • Stream
The final product images for the Entera (rendered by someone else) pulled from the Acuity Brands website.
Specification Sheet (page 1) for the Entera wall mount.
View PDF
Rendering of the Entera in a single patients hospital room. Room and luminaires were modeled in Solidworks. Rendering completed using Photoworks 2007.
1 of 3 final concepts rendered in Keyshot before 3D printing prototype (no picture taken). This concept was decided as the one to move forward with.
1 of 3 final concepts rendered in Keyshot before 3D printing prototype (no picture taken). This concept was not chosen
1 of 3 final concepts rendered in Keyshot before 3D printing prototype (no picture taken). This Concept was not chosen
Form study of initial concepts with more added interest to the simple form.
1 of 4 initial concepts chosen to move forward in the design process, taken from a large swath of concepts.
View PDF
1 of 4 initial concepts chosen to move forward in the design process, taken from a large swath of concepts.
View PDF
1 of 4 initial concepts chosen to move forward in the design process, taken from a large swath of concepts.
View PDF
1 of 4 initial concepts chosen to move forward in the design process, taken from a large swath of concepts.
View PDF
Final production horizontal wall mount Canoe fixture
Specification Sheet (page 1) for the Canoe horizontal wall mount.
View PDF
Final Production Vertical wall mount Canoe fixture
Specification Sheet (page 1) for the Canoe vertical wall mount.
View PDF
Given a few hours I put together a few concepts to review with my supervisor. We then presented the horizontal wall mount as an alternative to what was going to be used.
It was decided to go back and make adjustments before we finalized the design of the wall bracket. These are those last adjustments to review before passing off to the engineering/mechanical design team.
Given a few hours I put together a few concepts to review with my supervisor. We then presented this wall bracket as an alternative to what was going to be used with the final product. It was decided I should go back and make adjustments before finalizing.
I was tasked with designing the knuckle mount for the WinDirect LED line. As you can see I kept the profile slim at the mounting point to the housing to keep it accessible for maintenance but mostly out of sight. I also kept consistency with the overall design language, thus giving overall improvement of the knuckle mount over the original.
The first product I assisted in giving design advice on at Winona Lighting was the housing for the Parata and Blanca LED spot luminaires.
  • o
Lighting Design

This showcases the luminaires and accessories that I have assisted with that are currently in production.

Emma Hover
Industrial Designer Greenville, SC