• Stream
  • Portfolio
  • About
Ultimately, the clamshells were shot in phenolic material. These were shot in the production molds using polycarbonate.
The 1hp variant was used in this bar blender
Stock photo of the 1/3 hp variant
1hp Universal Motor for Bar Blender

To adapt a consumer grade blender motor concept to a commercial application. 4 variants of the design were put into production, a 1/3 hp variant with bushings and a 1hp variant with roller bearings, available in 120v or 240v.

Freelance, Full-time
Jason Duckworth
Design Engineer Charlotte, NC