Hand Table - The Hand Table is my favorite piece thus far made from maple and mahogany. The fingers are tensioned with nylon coated steel cable and turnbuckles. The base and top supports are made from 1/4" aluminum and the top is cur from 1/4" plexi.
Hand Table - A top view showing books between the top supports.
Hand Table - A close-up of the turnbuckles and aluminum base.
Hand Table - Another view of the Hand Table.
Plywood Chair - The chair is made from one piece of plywood and can be disassembled and reassembled for cleaning and/or transport.
Plywood Chair - This is the chair pre-finish. It actually looked good this way, but I needed some protection on it.
Plywood Chair - This is the chair in its disassembled state.
Checkerboard - The Checkerboard is made from zebra and blood woods. Each square are tongued and grooved with a bare edge to show craftsmanship.
Skeleton Table - This is a top view of the Skeleton Table. This is designed and rendered in AutoCAD 2008. I like the feeling of it showing like an x-ray.
Skeleton Table - Finished Model - Top-left View
Skeleton Table - Finished Model - Side View
Skeleton Table - Finished Model - Top-Front View
Ant Farm / Terrarium - A two-chambered vessel made from 3/8" plexi, it can house an ant farm and terrarium simultaniuously and separately.
Ant Farm / Terrarium - A two-chambered vessel made from 3/8" plexi, it can house an ant farm and terrarium simultaniuously and separately.
Ant Farm / Terrarium - A two-chambered vessel made from 3/8" plexi, it can house an ant farm and terrarium simultaniuously and separately.
gLike
Other Furniture Design
View Website
Jeremy Thayer
Designer III Houston, TX