• About
  • Portfolio
  • Stream
Trail Mudslinger
Comments (5)
  • nice & unusual design...that rox

    10 years ago

  • Joe, from my knowledge, as long as you can use a cam or slide, you can do these textures on undercut surfaces in injection molded plastics. It'll just increase your tool cost.

    10 years ago

  • I wish I could put textures like this on injection molded surfaces with undercuts. Flexible materials would be fun to work on for a while. Great shot!

    10 years ago

  • very cool outsole detail!!! great job

    10 years ago

  • LOVE THIS

    10 years ago

  • LOVE THIS

    10 years ago

  • very cool outsole detail!!! great job

    10 years ago

  • I wish I could put textures like this on injection molded surfaces with undercuts. Flexible materials would be fun to work on for a while. Great shot!

    10 years ago

  • Joe, from my knowledge, as long as you can use a cam or slide, you can do these textures on undercut surfaces in injection molded plastics. It'll just increase your tool cost.

    10 years ago

  • nice & unusual design...that rox

    10 years ago

Jonathan Fontaine
Senior Designer Detroit, MI